> Hard Drive
> Missing 2nd (IDE) Drive
Missing 2nd (IDE) Drive
Aug 31, 2010 #3 Leeky TS Evangelist Posts: 3,797 +116 You should be able to use the maximum amount of SATA devices for the given ports on your motherboard. Reply bill taylor says: September 8, 2008 at 5:01 pmthanks for the help! Reply James Scholes says: June 23, 2009 at 2:47 pmHi, I have a drive mounted in an external enclosure, on which the power supply has gone dead. Can someone please tell me how to change that?? check over here
I have lots of data on there that I need to keep can I install it without formatting? by billstott / September 24, 2004 6:49 AM PDT In reply to: That'sa clue. It had windows 2000 on it and i just want to save home movies on it. In the article, it mentioned that the PC should not be plugged into the internet until XP SP3 is installed; they then provided the link to d/l the SP3 patch.However, when http://www.sevenforums.com/hardware-devices/88850-missing-2nd-ide-drive-sata-weird-disc-sounds.html
How To Fix Undetected External Hard Drive
From reading your article, it sounds like I will have to format all data off the drive if I want it to be recognised by Windows? What is the cable select? however, when i installed the HDD, the system didn't work? Do you still need to have a jumper on the hard drive or does the microboard in the adapter handle that like the new SATA drives do?I ask because here's the
Reply mark says: December 18, 2008 at 12:29 pmworking on a computer with two hard drives. this didnt help i just got a black screen asking me to insert boot device. If one or more of these 5 issues are true, users will receive the disturbing error message Missing Operating System or Operating System not Found. How To Fix Undetected Hard Drive Rebuilding a Relic for my Kids.
Thanks a bunch David, I was really in a pickle. Reply curt says: July 12, 2009 at 9:49 amYou probably already figured it out…. In general, the master drive should use the black connector on the end and the slave should use the gray connector in the middle, but if each drive is set either http://www.tomshardware.com/answers/id-1750903/missing-undetected-hard-drive.html Reply Fred says: August 16, 2009 at 2:08 pmThanks to your excellent instructions I was able to install a new hard drive with only minor pain.
When I boot up with anything except a floppy, get, "operating system not found," when I boot up with any of the suggested startup boots which I downloaded on my workig Missing Hard Drive Windows 10 I try to extend it with no luck. For some people, such sketches help to put everything back when you are done.If you are replacing your old hard drive, remove the cables from the old drive. With both drives set to Cable Select, the computer will recognize the drive hooked up to the black end connector as the master and the one hooked up to the middle
Format Undetected Hard Drive
Do I just set the new drive as slave until I load the image to it and then powerdown and remove the old drive and set the new one to master? I would also trying switching to another SATA port on the drive that isn't being recognised. How To Fix Undetected External Hard Drive Facebook Google+ Twitter YouTube Subscribe to TechSpot RSS Get our weekly newsletter Search TechSpot Trending Hardware The Web Culture Mobile Gaming Apple Microsoft Google Reviews Graphics Laptops Smartphones CPUs Storage Cases How To Recover Undetected Hard Disk Join the community here, it only takes a minute.
By the way, I grew up in St. http://scientificpages.net/hard-drive/old-hard-drive.html doh, i just re-read you post and you said in the other computer it's fine. I have changed the jumpers on the IDE hard drive, but Windows does not see the second HD.Any suggestions on how to successfully install the second HD.Thanks, Reply Bob says: January The Windows ME version from www.bootdisk.com When I run that, it makes a bootable diskette with.. Hard Disk Undetected
http://www.pcguide.com/ref/hdd/if/ide/confCS-c.htmlAs to 40/80 WIRE or CONDUCTOR IDE cables, it's what is used on today's hard disks. If you are replacing your current drive and cloning it to your new drive, you will need to connect both drives. Tip: If you are unclear of internal structure of computer, please do not operate at random, because even a slight mistake may cause more serious damage. http://scientificpages.net/hard-drive/missing-space-in-c-how-to-recover.html Although one would expect that people attempting this would be somewhat computer savy, these instructions are meant more for the individual who can explain why Captain Picard is better than Captain
The cramped 3gb left on my drive will no longer bog me down or limit my media.Thank you Mr. Drive Not Showing Up In Disk Management xxx Reply walter says: August 17, 2007 at 12:47 amHello, I've been tring to install a SATA hard drive with no luck. Its simple:BECAUSE THE PEOPLE WHO DO KNOW WHAT IT MEANS WON'T NEED A GUIDE TO HELP THEM.Therefore, the people who don't know DO need a guide, but this guide is USELESS
Reply Glenn says: November 7, 2007 at 2:59 amSteve - if all is connected then u must format - see above under ‘Software Installation/Cloning'I've just added a second and had no
solved Lost Secondary IDE, Nothing will detect in the BIOS or in Windows XP MSI P965 auto-detection IDE Primary or Secondary not working solved Internal slave/secondary HDD keeps disconnecting solved Problem Reply greg says: April 27, 2009 at 9:12 pmI would first try cable select though I cannot verify the results. hello!!! Hard Drive Not Detected In Bios Update her on the status and the make of the drive and make certain that you understand the jumpering, if not let her explain it.
I nNever use Maxblaster ... The hard disk failed either physically or logically. 3. I am new to SATA drives, and used to EIDE so didn't know I had to initialize it.Thanks for the help. have a peek at these guys Recent Posts Menu Log in or Sign up [H]ard|Forum Forums > Bits & Bytes > Operating Systems > Sandy Bridge 2600K vs Kaby Lake 7700K CPU Showdown @ [H]ardOCP Dismiss Notice
I'll be back for more later. She is in the Eastern time zone. If one is not seen in the BIOS screens, it has a hardware problem.6. Problem arises when the system is running the operating system boots.
Yes, my password is: Forgot your password? If you don't know the difference between ide & sata then you need to read up on that before trying to fit a new disk drive or you'll end up buyiing I nNever use Maxblaster ... or what i'v done wrong?
The physical installation was easy - I just needed that last bit of help getting through the Windows XP disk management stage.As I write this, 500gb of new hard disk space Ok?1. Now, the C drive only has 550 mb on it & the "I" drive has 159 GB on it. You need to go into disk management to fix this problem.
If there is supposed to be a forth drive, it is not showing.As for missing files, could be the files are there and you just can't see them because the drive